Buy Needles and Syringes with NO PRESCRIPTION Synthetek Muscle Building And Fat Loss Products Cheap Pure Supplements
©ALL CONTENT OF THIS WEBSITE IS COPYRIGHTED AND CANNOT BE REPRODUCED WITHOUT THE ADMINISTRATORS CONSENT 2003-2020

The Original Euro Supplier The Original Euro Supplier The Original Euro Supplier
Largest Selection of Bodybuilding Products Largest Selection of Bodybuilding Products Largest Selection of Bodybuilding Products


AnaSCI Fitness EvolvedAnaSCI Fitness EvolvedAnaSCI Fitness EvolvedAnaSCI Fitness EvolvedAnaSCI Fitness Evolved

IGF Question / Measurement

naase2004

naase2004

Registered User
Jul 23, 2004
121
0
0
Charlotte, NC
its from ancillary guys and your right. Its a 1000mcg vial. I dont know how much ba to mix it with though. I am assuming if I put 10ml of ba in it then mix. Draw out 40 on a slin pin and that would be 40mcg of igf? is that right
 
BIGSARGE

BIGSARGE

Registered User
Oct 18, 2004
654
0
0
Not To Many Of Us Are Experts On Igf. Easiest Thing To Do Would Be To Email Ancillary Guys And Ask Them.
 
P

pincrusher

Guest
if you mix 10ml of water with the igf then you would have 100mcg per 1ml so on your slin pin if it has 100 lines and the pin holds 1ml of fluid then the 40line point would be 40mcg. this is a good way to mix the igf since lesser amounts of water will cause a higher dosing per ml and will result in some waste when injecting. alot of premixed igf comes in a 1ml vial like explained above and in that case, every 10 lines on the same slin pin would equal 100mcg.
 
You must log in or register to reply here.
Top Bottom