©ALL CONTENT OF THIS WEBSITE IS COPYRIGHTED AND CANNOT BE REPRODUCED WITHOUT THE ADMINISTRATORS CONSENT 2003-2020



Inch And Gauge

SandMan-WES

ANASCI'S YOUNG GUN
May 2, 2005
223
0
0
OK heres the deal i cant get 1inch 25 gauge pins. i have prob 6-8 % bf and was wonderin if i could use 5/8 to get the job done????? any input ?????
 
P

pincrusher

Guest
SandMan-WES said:
OK heres the deal i cant get 1inch 25 gauge pins. i have prob 6-8 % bf and was wonderin if i could use 5/8 to get the job done????? any input ?????
have you tried ordering on-line from one of the pin sources such as www.gearboxinc.com. i believe they have 25g 1" & 1.5". that is where i get all my pinz and they have always given great service.
if not then 5/8 will work in delts & probably quads with that low a bf% you could also get 1.5" and just not push them in all the way.