I got some test a few months ago and finally decided to use it pre workout on my ace & prop cycle. It all settled to the bottom. I kept it in a hot sink for about 30 minutes and it finally broke loose and I was able to mix it up in the amp. As I drew it in it was settling back down, so I shot some back in and drew quickly. I got a good portion of it in but not all. I tried to get the air out and it was clogged. I pushed so hard the pin blew off.
Is this normal? Do I need to do something else to get it back into solution properly?
Thanx
Is this normal? Do I need to do something else to get it back into solution properly?
Thanx