Buy Needles and Syringes with NO PRESCRIPTION Synthetek Muscle Building And Fat Loss Products Cheap Pure Supplements
©ALL CONTENT OF THIS WEBSITE IS COPYRIGHTED AND CANNOT BE REPRODUCED WITHOUT THE ADMINISTRATORS CONSENT 2003-2025

420x60 steroids warehouse
Largest Selection of Bodybuilding Products Largest Selection of Bodybuilding Products Largest Selection of Bodybuilding Products


AnaSCI Fitness EvolvedAnaSCI Fitness EvolvedAnaSCI Fitness EvolvedAnaSCI Fitness EvolvedAnaSCI Fitness Evolved

the aspiration

C

Cosmy

New member
May 2, 2007
9
0
0
I'm new here. G'day everybody. I am unsure about the aspiration issue.What does exactly?
 
You don't want to inject into an artery or vein! From our site...

"After inserting the pin into the muscle, pull back on the stopper for a few seconds to make sure it does not fill up with blood which would indicate that the needle had been injected into a blood vessel..."

I am guessing that's what you meant.
 
correct.... Just a quik draw back on the pin to mnake sure your not in a vein.
If its an airbubble your good...If it happens to be blood, ABORT mission!
 
The aspiration is when the needle is allready into the muscle, and you pull back the plunger. Now , if you don't see any blood coming up but few bubles of air, than you are ready to inject. If blood appears than you should pull out the needle imediately.
 
hey whats it when u inject all the oil in the muscle and a few drops of blood cums out once u pull the needle out as i forgot to aspirate
 
Arnie said:
hey whats it when u inject all the oil in the muscle and a few drops of blood cums out once u pull the needle out as i forgot to aspirate
Click to expand...
normal
 
crown said:
The aspiration is when the needle is allready into the muscle, and you pull back the plunger. Now , if you don't see any blood coming up but few bubles of air, than you are ready to inject. If blood appears than you should pull out the needle imediately.
Click to expand...

I thougt that there are supose to be no air bubles. I allways make sure that there are no bubles on the syringe before I inject. You could even dye if you inject air.
 
ana4me said:
I thougt that there are supose to be no air bubles. I allways make sure that there are no bubles on the syringe before I inject. You could even dye if you inject air.
Click to expand...
No air bubbles before you inject, but when you aspirate usually you get an air bubble or two...This is fine...Also you're not going to die from injecting a little air bubble in ya...It would really only matter if you were to inject a good deal of air into your vein...Don't do that:)
 
Look, first of all the chances of hitting a vein directly are very low, and even if you going to hit it you will probably will not die. Will not be pleasent either . About the air bubbles, embolism will happened just when an large one will be injected. The small ones will not harm you in any way.
 
You must log in or register to reply here.
Top Bottom
Back