|
| Home | Forums | AnaPRO Shop | F.A.Q | Injecting | Advertising | Contest Winners | Newsletters | Contact Us | Videos |
©ALL CONTENT OF THIS WEBSITE IS COPYRIGHTED AND CANNOT BE REPRODUCED WITHOUT THE ADMINISTRATORS CONSENT 2003-2025
  
|
|
|
  
|
injection question
- Thread starter Tainter
- Start date
I'd use a 22 gauge myself......are you injecting air into the vial first???? this creates a vaccum and replaces what you are taking out of the vial. So if you are gonna draw up 1cc of gear, first draw up 1cc of air, then insert into the vial, inject all the air, and the gear should suck up pretty good.
23 guage pinz are pretty small to be using for withdrawing product from vials. i use 18g or 20g at the smallest because when i go smaller than those i tend to pull up to much air and get alot of small bubbles in the syringe.
try ordering a box of 20g pinz from gearboxinc or getpinz and use them to withdraw the product then switch to the 23g for injecting. this will make the injection go easier also if you are currently using the same pin for drawing up product and injecting.
try ordering a box of 20g pinz from gearboxinc or getpinz and use them to withdraw the product then switch to the 23g for injecting. this will make the injection go easier also if you are currently using the same pin for drawing up product and injecting.
I agree with Pin 100% unless you have a 50ml jug of gear. If you use an 18g or 20g pin, you'll have no rubber left on top by the time you get towards the lower 1/2 of the bottle. 50ml jugs dont seem to be that common nowadays, but if you have them, use a 21 or 22g pin.
DragonRider
Steroid Nazi
I buy extra stoppers just for this purpose. When they get to the point that I'm afraid rubber might start falling into my vial, I replace the stopper.tee said:
