©ALL CONTENT OF THIS WEBSITE IS COPYRIGHTED AND CANNOT BE REPRODUCED WITHOUT THE ADMINISTRATORS CONSENT 2003-2020



Tren A Wont Stop Chrystalizing

Smack

Registered User
Apr 7, 2014
27
0
0
So initially the Tren kept re-chrystalizing even heated in hot water (not boiling but bubbles forming on sides of container) and I was sent a replacement Tren A.

Well it's happening again every time even when heating and vigorously shaking... Any suggestions?

Thanks
 

Sully

AnaSCI VET / Donating Member
Dec 3, 2012
3,324
0
36
Just heat it up so it goes back into solution before you draw and inject. Shouldn't really be a problem.
 

Sully

AnaSCI VET / Donating Member
Dec 3, 2012
3,324
0
36
Ok, that changes the story. If you want to, you could try cutting it with some more oil and lowering the effective mg/ml of the end solution. Or it might just need a little more BB as a solvent to help it stay in solution.
 

Smack

Registered User
Apr 7, 2014
27
0
0
Ok, that changes the story. If you want to, you could try cutting it with some more oil and lowering the effective mg/ml of the end solution. Or it might just need a little more BB as a solvent to help it stay in solution.

Thank you, I'll try that asap.