Short ester primo?

Why not make it transdermal application cream using Phlogel?
The molar weight of methenolone acetate is low enough for transdermal application and there is quite a bit of research so far with people using test base and the absorbtion rates so it's technically possible. Since the delivery method removes the esther i was asking if it's possible to use methenelone enanthate as a transdermal, but looks like no cigar on that one.

Here's a conversation i had with a Phlogel rep about it:

The ester will be cleaved, either once blended into PhloJel Ultra or as it
passes through the dermis. I would imagine the effects to be that of
testosterone base - fast acting with similar half life, with a lower
concentration of the hormone per mg of weight once the ester is taken into
account. The compound you mention, Primobolan, is listed in my index as
Methenolone acetate which has a molecular weight of 344 Daltons and would be
acceptable for transdermal delivery. You indicated that it is an enanthate.
Methenolone Enanthate (Primobolan Depot) has a molecular weight of 414
Daltons, just over the acceptable limit and would not be a good candidate
for transdermal delivery.

As for delivery rates, lecithin organogel carriers have been reported to
have between ~40% and ~60% delivery rates. PhloJel Ultra is a superior blend
lecithin organogel with penetration enhancers. Users report results that
would indicate upwards of 50% absorption rates.

There is a lecithin organogel using testosterone on the website at
http://www.phlojel.us/dl/Lecithin Organogels and Testosterone.PDF

So once you get a dosage and some legit powder you are off to the races.