- Aug 30, 2004
- 282
- 0
- 0
i was practicing preparing the syringe with water earlier, heres the steps i went through...
1) pull back the syringe to the amount you want it at (in this case 1cc)
2) put the needle in the vial upside down and push the air into it.
3) withdraw the dirsired amount fronm the vial (1cc)
4) pull the syringe back out the vial and hold it upside down.
5) flick all the air bubbles out of it.
number 5 is where i had the problem...
i can flick all the big air bubbles out but there are a few of these little tiny micro air bubbles that just wont go up the the top...they just kinda stay there in the middle. what should i do? is it ok to inject? if it is im assuming it'll hurt i little. Thanks bros.
1) pull back the syringe to the amount you want it at (in this case 1cc)
2) put the needle in the vial upside down and push the air into it.
3) withdraw the dirsired amount fronm the vial (1cc)
4) pull the syringe back out the vial and hold it upside down.
5) flick all the air bubbles out of it.
number 5 is where i had the problem...
i can flick all the big air bubbles out but there are a few of these little tiny micro air bubbles that just wont go up the the top...they just kinda stay there in the middle. what should i do? is it ok to inject? if it is im assuming it'll hurt i little. Thanks bros.