Tren A Wont Stop Chrystalizing

[Smack]

So initially the Tren kept re-chrystalizing even heated in hot water (not boiling but bubbles forming on sides of container) and I was sent a replacement Tren A.

Well it's happening again every time even when heating and vigorously shaking... Any suggestions?

Thanks

 

[Sully]

Just heat it up so it goes back into solution before you draw and inject. Shouldn't really be a problem.

 

[Smack]

Just heat it up so it goes back into solution before you draw and inject. Shouldn't really be a problem.

Thats what I've been doing but even when heated the chrystals dont fully dissolve.

 

[Sully]

Ok, that changes the story. If you want to, you could try cutting it with some more oil and lowering the effective mg/ml of the end solution. Or it might just need a little more BB as a solvent to help it stay in solution.

 

[Smack]

Ok, that changes the story. If you want to, you could try cutting it with some more oil and lowering the effective mg/ml of the end solution. Or it might just need a little more BB as a solvent to help it stay in solution.

Thank you, I'll try that asap.

 

[Ironbuilt]

Prob cooked the chems right out of it making crystals harder .

 

[Enigmatic707]

prob cooked the chems right out of it making crystals harder .

x2

 

[Smack]

Prob cooked the chems right out of it making crystals harder .

I did by heating it in water or you meant the sponsor (I didnt brew it)?

Anyway, it was fine after adding a bit more oil...